Ethernet Cfm Commands; Commands In This Chapter - Dell Networking 7048 Reference Manual

Ethernet CFM Commands

Connectivity Fault Management (CFM) is the OAM Protocol provision for
end-to-end service layer OAM in carrier Ethernet networks. CFM provides
mechanisms to support the operator in performing connectivity checks, fault
detection, fault verification and isolation, and fault notification per service in
the network domain of interest. Unlike Ethernet OAM defined in IEEE
802.3ah, where the faults are detected and notified on a single point-to-point
IEEE Std. 802.3 LAN, this specification deals with the fault diagnosis at
service layer across networks comprising multiple LANs, including LANs
other than 802.3 media.
PowerConnect CFM supports the following functionality:
• Path discovery (linktrace message)
• Fault detection (continuity check message)
• Fault verification and isolation (loopback and linktrace messages)
• Fault notification (alarm indication signal or SNMP trap)

Commands in this Chapter

This chapter explains the following commands:
ethernet cfm domain
service
ethernet cfm cc level
ethernet cfm mep level
ethernet cfm mep enable
ethernet cfm mep active
ping ethernet cfm
traceroute ethernet cfm
show ethernet cfm errors
show ethernet cfm domain
show ethernet cfm maintenance-points
local
show ethernet cfm maintenance-points
remote
Ethernet CFM Commands
16
445