Dell Networking 7048 Reference Manual page 295

{deny | permit} {every | {{icmp | igmp | ip | tcp | udp |
srcmask portkey
[{eq {
precedence
[precedence
time-range-name
Parameter Description
This command does not require a parameter description.
Default Configuration
This command has no default configuration.
Command Mode
Ipv4-Access-List Configuration mode
User Guidelines
Administrators are cautioned to specify permit and deny rule matches as fully
as is possible in order to avoid false matches. Rules that specify a port value
should also specify the protocol and ethertype. Rules that specify a protocol
should also specify the ethertype value for the frame. In general, any rule that
specifies matching on an upper layer protocol field should also include
matching constraints for lower layer protocol fields. For example, a rule to
match packets directed to the well-known UDP port number 22 (SSH)
should also include constraints on the IP protocol field (UDP) and the
ethertype field (0x800 – IPv4). Below is a list of commonly used ethertypes:
Ethertype
0x0800
0x0806
0x0842
0x8035
0x8100
0x86DD
0x8808
0-65535
| }
tos tosmask
| tos
queue-id
] [assign-queue
Protocol
Internet Protocol version 4 (IPv4)
Address Resolution Protocol (ARP)
Wake-on LAN Packet
Reverse Address Resolution Protocol (RARP)
VLAN tagged frame (IEEE 802.1Q)
Internet Protocol version 6 (IPv6)
MAC Control
dstip dstmask
[{eq {
dscp
| dscp
] [{mirror | redirect}
number srcip
}
portkey 0-65535
|
] [log] [time-range
interface-id
ACL Commands
}]
]
295