Commands In This Chapter - Dell Networking 7048 Reference Manual

In order to enable Private VLAN operation across multiple switches which are
not stacked, the inter-switch links should carry VLANs which belong to a
private VLAN. The trunk ports which connect neighbor switches have to be
assigned to the primary, isolated, and community VLANs of a private VLAN.
In regular VLANs, ports in the same VLAN switch traffic at L2. However for
private VLAN, the promiscuous port is in the primary VLAN whereas the
isolated or community ports are in the secondary VLAN. Similarly, for
broadcasts, in regular VLANs, ports in the same VLAN receive broadcast
traffic. However, for private VLANs, the ports to which the broadcast traffic is
forwarded depend on the type port on which the traffic was received. If the
received port is a host port; the traffic is forwarded to all promiscuous and
trunk ports. If the received port is community port the broadcast traffic is
forwarded to promiscuous, trunk and community ports in the same VLAN. A
promiscuous port sends traffic to other promiscuous ports, isolated and
community ports.

Commands in this Chapter

This chapter explains the following commands:
dvlan-tunnel
ethertype
console(config-if-
vlan10)#
interface vlan
interface range vlan show port protocol switchport general
mode dvlan-tunnel show vlan
name (VLAN
Configuration)
protocol group
808
VLAN Commands
show dvlan-tunnel
show dvlan-tunnel
interface
show interfaces
switchport
show vlan
association mac
show vlan
association subnet
switchport general
acceptable-frame-
type tagged-only
switchport general
allowed vlan
switchport general
ingress-filtering
disable
pvid
switchport mode
switchport trunk
vlan
vlan association subnet
vlan database
vlan makestatic
vlan protocol group
vlan protocol group add
protocol
vlan protocol group
name
vlan protocol group
remove