Ipv6 Enable (Oob Config); Ipv6 Gateway (Oob Config) - Dell Networking 7048 Reference Manual

ipv6 enable (OOB Config)

Use the ipv6 enable command in Interface (out-of-band) Config mode to
enable IPv6 operation on the out-of-band interface. Prefixes configured by
the ipv6 address command are not configured until the interface is enabled.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.

ipv6 gateway (OOB Config)

Use the ipv6 gateway command in Interface (out-of-band) Config mode to
configure the address of the IPv6 gateway. The gateway is used as a default
route for packets addressed to network devices not present on the local
subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6 gateway ipv6-address
no ipv6 gateway
Parameter Description
Parameter
ipv6-address
526
IP Addressing Commands
Description
An IPv6 address (not a prefix).