Switchport Trunk - Dell Networking 7048 Reference Manual

Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example configures 1/0/5 to access mode.
console(config)#interface gigabitethernet 1/0/5
console(config-if-1/0/5)#switchport mode access

switchport trunk

Use the switchport trunk command in Interface Configuration mode to add
VLANs to or remove VLANs from a trunk port, or to set the native VLAN for
an interface in Trunk Mode.
Syntax
vlan–list vlan–id
switchport trunk {allowed vlan | native vlan }
no switchport trunk allowed vlan
834
VLAN Commands