Show Classofservice Dot1P-Mapping - Dell Networking 7048 Reference Manual

Class Name..................................... stop_http_class
Class Type..................................... All
Class Layer3 Protocol.......................... ipv6
Match Criteria
---------------------------- -------------------------------------
Source IP Address
Source Layer 4 Port

show classofservice dot1p-mapping

Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port | port-
port-channel-number | tengigabitethernet unit/slot/port}]
channel
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
If the interface is specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are
displayed.
Example
The following example displays the dot1p traffic class mapping and user
priorities.
console#show classofservice dot1p-mapping
User Priority
704
QoS Commands
2001:DB8::/32
80(http/www)
Traffic Class
Values