Switchport General Ingress-Filtering Disable - Dell Networking 7048 Reference Manual

User Guidelines
You can use this command to change the egress rule (for example, from
tagged to untagged) without first removing the VLAN from the list.
Example
The following example shows how to add VLANs 1, 2, 5, and 8 to the allowed
list.
console(config-if-1/0/8)#switchport general allowed vlan add 1,2,5,8 tagged

switchport general ingress-filtering disable

Use the switchport general ingress-filtering disable command in Interface
Configuration mode to disable port ingress filtering. To enable ingress
filtering on a port, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to enables port ingress filtering on 1/0/8.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport general ingress-filtering disable
831
VLAN Commands