Ipv6 Address Dhcp - Dell Networking 7048 Reference Manual

User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
configuration or DHCPv6 is not enabled on any of the in-band management
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the
in-band management interfaces.

ipv6 address dhcp

Use the ipv6 address dhcp command in Interface (VLAN) Configuration
mode to enable the DHCPv6 client on an IPv6 interface.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Parameter Description
This command does not require a parameter description.
Default Configuration
DHCPv6 is disabled by default on routing interfaces.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only applies to VLAN routing interfaces. When DHCPv6 is
enabled on a VLAN routing interface, the system automatically deletes all
manually configured IPv6 addresses on the interface.
Use the no ipv6 address dhcp command to release a leased address and to
disable DHCPv6 on an interface. The command no ipv6 address does not
disable the DHCPv6 client on the interface.
524
IP Addressing Commands