Ipv6 Enable (Interface Config) - Dell Networking 7048 Reference Manual

This command will fail if DHCPv6 server has been configured on the
interface.
Examples
In the following example, DHCPv6 is enabled on interface vlan2.
console#config
console(config)#interface vlan2
console(config-if-vlan2)#ipv6 address dhcp

ipv6 enable (Interface Config)

Use the ipv6 enable command in Interface Config mode to enable IPv6 on a
routing interface. Use the no form of this command to reset the IPv6
configuration to the defaults.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is not enabled by default.
Command Mode
Interface Configuration mode (VLAN, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
525
IP Addressing Commands