Match Ethertype - Dell Networking 7048 Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the
destination layer 4 port of a packet using the "echo" port name keyword.
console(config-classmap)#match dstl4port echo

match ethertype

Use the match ethertype command in Class-Map Configuration mode to add
a match condition based on the value of the ethertype.
Syntax
match ethertype {keyword |
• keyword — Specifies either a valid keyword or a valid hexadecimal number.
The supported keywords are appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, netbios, novell, pppoe, rarp. (Range:
0x0600–0xFFFF)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a match condition based on
ethertype.
console(config-classmap)#match ethertype arp
684
QoS Commands
0x0600-0xffff }