Show Lacp - Dell Networking 7048 Reference Manual

Example #1
console#show interfaces port-channel
ChannelPorts ChTypeHash Algorithm Typemin-Links
------------------------- -----------------------------------
Po1Inactive: Gi1/0/3Dynamic31
Po2No Configured PortsStatic31
Hash Algorithm Type
1 - Source MAC, VLAN, Ethertype, source module and port ID
2 - Destination MAC, VLAN, Ethertype, source module and port ID
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, Ethertype, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
Example #2
console#show interfaces port-channel 1
Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- ---------- --------- --------
-
Po1 Inactive: Gi1/0/1, Gi1/0/2, Dynamic 3 1 Enabled
Gi1/0/3, Gi1/0/4

show lacp

Use this command in Privileged EXEC mode to display LACP information
for Ethernet ports.
Syntax
port-channel-number
show lacp {gigabitethernet unit/slot/port| port-channel
| tengigabitethernet unit/slot/port [{parameters | statistics}]
Default Configuration
This command has no default configuration.
646
Port Channel Commands