Debug Udld - Dell Networking 7048 Reference Manual

Field
UDLD Status
Default Configuration
This command has no default setting.
Command Mode
Privileged EXEC or User EXEC mode, Config mode and all Config sub-
modes
User Guidelines
This command has no user guidelines.

debug udld

Use the debug udld command in Privileged EXEC mode to enable the
display of UDLD packets or event processing.
Use the no form of the command to disable debugging.
Syntax
debug udld {packet [receive|transmit]|events}
no debug udld {packet [receive|transmit]|events}
Description
The status of the link as determined by UDLD. The options
are:
• Undetermined – UDLD has not collected enough information
to determine the state of the port.
• Not applicable – UDLD is disabled, either globally or on the
port.
• Shutdown – UDLD has detected a unidirectional link and
shutdown the port. That is, the port is in an errDisabled state.
• Bidirectional - UDLD has detected a bidirectional link.
• Undetermined (Link Down) – The port would transition into
this state when the port link physically goes down due to any
reasons other than the port being put into D-Disable mode by
the UDLD protocol on the switch.
UDLD Commands
801