Release Dhcp - Dell Networking 7048 Reference Manual

renew dhcp

release dhcp

Use the release dhcp command in Privileged EXEC mode to force the
DHCPv4 client to release a leased address.
Syntax
interface-id
release dhcp
Parameter Description
Parameter
interface-id
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
The DHCP client sends a DHCP RELEASE message telling the DHCP
server that it no longer needs the IP address, and that the IP address can be
reassigned to another client. The interface method does not change and will
still be DHCP even after issuing this command. To lease an IP address again,
issue either the renew dhcp
(Interface Config)
address on the interface was not assigned by DHCP , then the command fails
and displays the following error message:
Interface does not have a DHCP-originated address.
The release dhcp option is applicable only for routing interfaces and not for
Out-of-Band port. Use the
Out-of-Band interface to clear a DHCP-acquired address.
360
DHCP Management Interface Commands
Description
Any valid VLAN interface. See
for interface representation.
interface-id
command on page 516 in interface mode. If the IPv4
ip address (Out-of-Band) none
show dhcp lease
Interface Naming Conventions
command below or ip address dhcp
command on the