Switchport Voice Detect Auto - Dell Networking 7048 Reference Manual

Po10
Po11
Po12
Po13
Po14
Po15
--More-- or (q)uit
The following example shows command output when a port is specified:
console#show switchport voice gigabitethernet 1/0/1
Interface
---------
Gi1/0/1
The command output provides the following information:
• AutoVoIP Mode—The Auto VoIP mode on the interface.
• Traffic Class—The Cos Queue or Traffic Class to which all VoIP traffic is
mapped. This is not configurable and defaults to the highest COS queue
available in the system for data traffic.

switchport voice detect auto

The switchport voice detect auto command is used to enable the VoIP Profile
on all the interfaces of the switch (global configuration mode) or for a specific
interface (interface configuration mode).Use the no form of the command to
disable the VoIP Profile.
330
Auto-VoIP Commands
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Auto VoIP Mode Traffic Class
-------------- -------------
Disabled
6
6
6
6
6
6
6