Show Interfaces Counters - Dell Networking 7048 Reference Manual

Field Description
Port Type The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Admin State Displays whether the port is enabled or disabled.

show interfaces counters

Use the show interfaces counters command in User EXEC mode to display
traffic seen by the interface.
Syntax
show interfaces counters [gigabitethernet unit/slot/port | port-channel
channel-number | tengigabitethernet unit/slot/port ]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays traffic seen by the physical interface:
console>show interfaces counters
Port InOctets
---- ----------
1/0/1 183892
InUcastPkts
---------
1289
Ethernet Configuration Commands
port-
423