Ipv6 Address (Oob Port) - Dell Networking 7048 Reference Manual

console(config)#no ipv6 address

ipv6 address (OOB Port)

Use the ipv6 address command in Interface (out-of-band) Config mode to set
the IPv6 prefix on the out-of-band port. If a prefix is specified, the address
will be configured using the prefix and length A link local address in EUI-64
format may also be assigned.
The autoconfig parameter specifies that a link local address in the EUI-64
format is assigned to the interface.
The DHCP parameter indicates that the port should obtain its address va
DHCP.
Use the no form of the command to remove a specific address or to return the
address assignment to its default value. Using the no form of the command
with no parameters removes all IPv6 prefixes from the interface.
Syntax
prefix/prefix-length
ipv6 address {
no ipv6 address {
Parameter Description
Parameter
prefix/prefix-length An IPv6 prefix in global format address format.
eui64
autoconfig
dhcp
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
prefix/prefix-length
Description
Formulate the prefix in EUI-64 format.
Perform IPv6 auto-configuration.
Obtain the prefix via DHCP.
[eui64] | autoconfig | dhcp}
[eui64] | autoconfig | dhcp}
IP Addressing Commands
523