Show Storm-Control - Dell Networking 7048 Reference Manual

show storm-control

Use the show storm-control command in Privileged EXEC mode to display
the configuration of storm control.
Syntax
show storm-control [all | {gigabitethernet unit/slot/port |
tengigabitethernet unit/slot/port }]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following example shows storm control configurations for all valid
Ethernet ports. The second example shows flow control mode status.
console#show storm-control all
Bcast
Intf Mode
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5
1/0/2 Disable 5
1/0/3 Disable 5
1/0/4 Disable 5
console#show storm-control
802.3x Flow Control Mode.................... Disable
436
Ethernet Configuration Commands
Bcast Mcast
Level Mode
Disable 5
Disable 5
Disable 5
Disable 5
Mcast Ucast
Level Mode
Disable 5
Disable 5
Disable 5
Disable 5
Ucast
Level