Show Interfaces Switchport - Dell Networking 7048 Reference Manual

console#show dvlan-tunnel interface 1/0/1
Interface Mode
--------- ------- --------------
1/0/1
The following table describes the significant fields shown in the example.
Field
Mode
Interface
EtherType

show interfaces switchport

Use the show interfaces switchport command in Privileged EXEC mode to
display switchport configuration, including the private VLAN mappings.
Syntax
show interfaces switchport {{gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port}}
Parameter Description
The command displays the following information.
Parameter
private-vlan host-
association
EtherType
Enable vMAN
Description
This field specifies the administrative mode through which
Double VLAN Tunneling can be enabled or disabled. The default
value for this field is
Interface Number.
This field represents a 2-byte hex EtherType to be used as the first
16 bits of the DVLAN tunnel. The three different EtherType tags
are: (1) 802.1Q, which represents the commonly used value of
0x8100. (2) vMAN, which represents the commonly used value of
0x88A8. (3) If EtherType is not one of these two values, it is a
custom tunnel value, representing any value in the range of 0 to
65535.
Description
Displays VLAN association for the private-VLAN host ports.
disabled
.
VLAN Commands
819