Enable Authentication - Dell Networking 7048 Reference Manual

User Guidelines
When command authorization is configured for a line-mode, the switch
sends information about the entered command to the method specified in
the command list. The authorization method validates the received
command and responds with either a PASS or FAIL response. If approved, the
command is executed. Otherwise, the command is denied and an error
message is shown to the user. If contact with the authorization method fails,
then the next method in the list is attempted.
Examples
Use the following command to enable TACACS command authorization for
telnet.
console(config)#line telnet
console(config-telnet)# authorization commands
mycmdAuthList

enable authentication

Use the enable authentication command in Line Configuration mode to
specify the authentication method list when accessing a higher privilege level
from a remote telnet or console. To return to the default specified by the
enable authentication command, use the no form of this command.
Syntax
enable authentication {default |
no enable authentication
• default — Uses the default list created with the aaa authentication enable
command.
list-name — Uses the indicated list created with the aaa authentication
•
enable command. (Range: 1-12 characters)
Default Configuration
Uses the default set with the command aaa authentication enable.
list-name
}
AAA Commands
259