Selecting The Measurement Unit - Omron Z4LB V2 Instruction Manual

Selecting the Measurement Unit

3-1 Selecting the Measurement Unit
The measurement unit can be set to linear output voltage (V) or
length (mm). In the following example, the unit is set to mm.
Set the measurement unit selector to mm.
The Sensor will display in millimeters.
Z4LB-S30V2 Sensor
The default setting for the measurement width of the Z4LB-CV2
Amplifier and Z4LB-CPV2 Amplifier is 10 mm. The measure-
ment width of the Z4LB-S30V2 is 30 mm. Therefore, if the Z4LB-
CV2 or Z4LB-CPV2 Amplifier is connected to the Z4LB-S30V2,
the Amplifier cannot convert a linear output voltage range be-
tween 1 and 5 V into length correctly unless the measurement
width of the Amplifier is changed to 30 mm. There is no need to
change the measurement width for a One-side Interruption High-
precision Sensor.
Note Before using the Z4LB-S10V2 Sensor, check that the measure-
ment width is set to 10 mm. Refer to steps 1, 2, and 4.
24
Display
Section 3-1