Replacing The Management Ethernet Cable; Replacing The Console Or Auxiliary Cable; Figure 44: Routing Engine Ethernet Cable Connector; Figure 45: Routing Engine Interface Ports - Juniper M7i Hardware Manual

Replacing the Management Ethernet Cable

See Also

Replacing the Console or Auxiliary Cable

Copyright © 2019, Juniper Networks, Inc.
To replace the management Ethernet cable:
Press the tab on the connector on the management Ethernet cable and pull the
1.
connector straight out of the port.
Disconnect the cable from the network device.
2.
Plug one end of the replacement Ethernet cable into the
3.
Figure 45 on page 145).
Plug the other end of the cable into the network device.
4.

Figure 44: Routing Engine Ethernet Cable Connector

Figure 45: Routing Engine Interface Ports

Fiber-Optic and Network Cable Specifications for the M7i Router on page 91
M7i Chassis Description on page 11
FIC Specifications for the M7i Router on page 45
Replacing the Console or Auxiliary Cable on page 145
If a cable is already connected to the
to remove it:
Turn off the power to the console or auxiliary device.
1.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
2.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
Chapter 23: Replacing Host Subsystem Components
Figure 44 on page 145 shows the connector.
MGMT
or
CONSOLE AUX/MODEM
port (see
port, follow these steps
145