Replacing The T320 Console Or Auxiliary Cable - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide

Replacing the T320 Console or Auxiliary Cable

182
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. If you want to
connect a device to both ports, you must supply another cable.
To connect a management console or auxiliary device:
Plug one end of the replacement cable into the appropriate
1.
port. Figure 67 on page 183
HOST 0 connect to the Routing Engine in the upper Routing Engine slot (
the ports labeled
HOST 1
slot ( RE1 ).
Plug the other end of the cable into the device's serial port.
2.
port on the CIP. Both ports accept a cable with
AUXILIARY
shows the external device ports on the CIP. The ports labeled
connect to the Routing Engine in the lower Routing Engine
or
CONSOLE AUXILIARY
RE0 ), and
Copyright © 2018, Juniper Networks, Inc.