Replacing An M10I Ethernet Management Cable; Removing A Management Ethernet Cable; Installing A Management Ethernet Cable; Replacing An M10I Console Or Auxiliary Cable - Juniper M10i Hardware Manual

Related
Documentation

Replacing an M10i Ethernet Management Cable

Replacing an M10i Console or Auxiliary Cable

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Preventing Electrostatic Discharge Damage to an M10i Router on page 150
Installing the M10i Routing Engine on page 134
M10i Routing Engine Architecture Overview on page 33
Maintaining the M10i Routing Engine on page 83
Troubleshooting the M10i Routing Engine on page 88
The port on the Routing Engine accepts Ethernet cable with and RJ-45 connector.
MGMT
For cable specifications, see "Routing Engine Interface Cable and Wire Specifications for
M10i Routers" on page 200:

Figure 60: Routing Engine Ethernet Cable Connector

Figure 61: Ethernet Management Port

Removing a Management Ethernet Cable on page 141
1.
Installing a Management Ethernet Cable on page 141
2.

Removing a Management Ethernet Cable

Press the tab on the connector and pull the connector straight out of the port. Figure
1.
60 on page 141 shows the connector.
Disconnect the cable from the network device.
2.

Installing a Management Ethernet Cable

Plug one end of the replacement Ethernet cable into the
1.
page 141 shows the ports on the routing engine.
Plug the other end of the cable into the network device.
2.
The CONSOLE and AUX ports on the Routing Engine accept an RS-232 (EIA-232) serial
cable with a DB-9 connector. For cable specifications, see "Routing Engine Interface
Cable and Wire Specifications for M10i Routers" on page 200.
Chapter 15: Replacing M10i Hardware Components
port. Figure 61 on
MGMT
141