Replacing The M40E Console Or Auxiliary Cable; Figure 82: Routing Engine Interface Ports And Alarm Relay Contacts - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide

Replacing the M40e Console or Auxiliary Cable

166
All manuals and user guides at all-guides.com
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. To connect a
device to the other port, you must supply another cable. For cable specifications, see
"Routing Engine Interface Cable and Wire Specifications for the M40e Router" on page 288.

Figure 82: Routing Engine Interface Ports and Alarm Relay Contacts

To connect a management console or auxiliary device:
Plug one end of the replacement cable into the appropriate
1.
port.Figure 82 on page 166 shows the external device ports on the CIP. The ports labeled
HOST 0 connect to the Routing Engine in the upper Routing Engine slot (
the ports labeled
HOST 1
slot ( ).
RE 1
port on the CIP. Both ports accept a cable with
AUXILIARY
connect to the Routing Engine in the lower Routing Engine
or
CONSOLE AUXILIARY
RE 0 ), and
Copyright © 2010, Juniper Networks, Inc.