07/11/02 09:20:24 61TA0000_110_0425
24. Turn the ignition switch to ON (II).
25. Reset the ECM/PCM with the HDS.
26. Do the ECM/PCM idle learn procedure (see page
11-343).
27. Start the engine. Hold the engine speed at
3,000 rpm without load (A/T in P or N, M/T in
neutral) until the radiator fan comes on, then let it
idle.
28. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P1454 and/ or P2422 indicated?
YES
−
Check for poor connections or loose
terminals at the FTP sensor, the EVAP canister vent
shut valve, and the ECM/PCM, then go to step 1.
−
NO
Go to step 29.
29. Monitor the OBD STATUS for DTC P1454 in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
−
YES
Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 28,
go to the indicated DTC's troubleshooting.
NO
−
If the screen indicates FAILED, check for poor
connections or loose terminals at the FTP sensor,
the EVAP canister vent shut valve, and the ECM/
PCM, then go to step 1. If the screen indicates NOT
COMPLETED, keep idling until a result comes on.
DTC P145C:
EVAP System Purge Flow
Malfunction
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
• If DTC P145C is indicated alone, do the
troubleshooting for DTC P0496 and P0497 using
freeze data for P145C.
• If DTC P0497 and P145C are stored at the same time,
check for a poor connection, a blockage, or damage
at the EVAP canister purge line between the EVAP
canister purge valve and the EVAP canister, or a stuck
closed EVAP canister purge valve.
• If any of DTCs listed below are indicated at the same
time as DTC P145C, troubleshoot those DTCs first,
then recheck for P145C.
P0496, P0497: EVAP system purge flow
TA08AEAK7210009145CFAAT00
11-425
11-425