Procedure 28 Configuring The Call Server Elan Network Interface Ip Address Active Elnk), Tlan Voice Port, And Routes - Avaya Nortel Communication Server 1000 Manual

3
Configure ELAN IP address, TLAN voice port, and routes
The LAN configuration section is used for configuring the Call Server ELAN
IP address (Active ELNK), TLAN voice port, and routes.
This information is applicable only to Small Systems.
Procedure 28
Configuring the Call Server ELAN network interface IP address (Active ELNK),
TLAN voice port, and routes
Step
1
Copyright © 2003–2008, Nortel Networks
.
Configure IP Line data using Element Manager 291
a. Diffserv CodePoint (DSCP) Control packets: A value of 40 -
Class Selector 5 (CS5). The range is 0 to 63. This configures
the priority of the signaling messaging.
b. Diffserv CodePoint (DSCP) Voice packets: A value of 46
Control DSCP - Expedited Forwarding (EF). The range is 0 to 63.
802.1Q enables Virtual LANs (VLANs) to be defined within a single
LAN. This improves bandwidth management and limits the impact of
broadcast storms and multicast messages.
a. Enable 802.1Q support: 802.1Q support is disabled by default.
b. 802.1Q Bits value (802.1p): The priority field is a 3-bit value,
with a default value of 6. The range is 0 to 7. A value of 6 is
recommended by Nortel. The p bits within the 802.1Q standard
enables packet prioritization at Layer 2, improving network
throughput for IP Telephony data.
Action
In the Edit window, click the plus sign (+) to the left of LAN
Configuration.
See Figure 67 " LAN configuration window" (page
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
—End—
292).