Avaya Definity SI Maintenance Manual page 1606

Maintenance Object Repair Procedures
External Device Alarm Test (#120)
The External Device Alarm Test requests the state of the External Device Alarm
from the Maintenance circuit pack and reports the results. The test has no effect
on the external device itself.
Table 10-299. TEST #120 External Device Alarm Test
Error
Code
1000
2000
10-820 Issue 4 May 2002
Test
Result
ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to ABORT with error code 2000, check
for system powering problems with the A carrier (PPN or
EPN). Look for and resolve all AC-POWER and
CARR-POW alarms in a multicarrier cabinet or
DC-POWER alarms in a single carrier cabinet. Then,
repeat the test.
3. If the test continues to ABORT with a 2000 error code,
check for and resolve all SYSAM errors in a PPN or
MAINT (EPN Maintenance circuit pack) errors in an EPN.
Then, repeat the test.
4. If the test continues to ABORT with a 2000 error code,
then escalate the problem.
Description/Recommendation
Continued on next page
555-233-123