Power:switch:ireference - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:POWer:SWITch:IREFerence

Command Syntax
:POWer:SWITch:IREFerence <percent>
<percent> ::= percent in NR1 format
The :POWer:SWITch:IREFerence command to specify the current switching
level for the start of switching edges. The value is in percentage of the
maximum switch current.
You can adjust this value to ignore noise floors or null offset that is
difficult to eliminate in current probes.
This value specifies the threshold that is used to determine the switching
edges.
Query Syntax
:POWer:SWITch:IREFerence?
The :POWer:SWITch:IREFerence query returns the current switching level
percent value.
Return Format
<percent><NL>
<percent> ::= percent in NR1 format
See Also •
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
":POWer:SWITch:APPLy"
":POWer:SWITch:CONDuction"
":POWer:SWITch:RDS"
":POWer:SWITch:VCE"
":POWer:SWITch:VREFerence"
on page 585
on page 586
on page 588
on page 589
on page 590
24
:POWer Commands
587