Power:signals:vsteady:onoff:off - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:SIGNals:VSTeady:ONOFf:OFF

Command Syntax
:POWer:SIGNals:VSTeady:ONOFf:OFF <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady:ONOFf:OFF command specifies the expected
steady state output DC voltage of the power supply for turn off analysis.
Query Syntax
:POWer:SIGNals:VSTeady:ONOFf:OFF?
The :POWer:SIGNals:VSTeady:ONOFf:OFF query returns the expected steady
state voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also •
•
•
•
•
•
•
•
578
(see page 1138)
":POWer:ONOFf:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:DURation:ONOFf:OFF"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:OVERshoot"
":POWer:SIGNals:VMAXimum:ONOFf:OFF"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 553
on page 564
on page 569
on page 573
on page 574
on page 576
on page 581
on page 582