Example: Using Network Ports As 40-Gigabit Ethernet Interfaces; Figure 5: 40-Gigabit Ethernet Interface Configuration Uses Three Network - Juniper PTX1000 Hardware Manual

PTX1000 Packet Transport Router Hardware Guide
24
NOTE: Port speeds are configured using the
port-number speed speed
by using the
40g
by using the
100g
or 100 Gbps, and you want to return the port to the default configuration,
delete the speed
0 port port-number]
port is reset to the default 4 x 10-Gigabit Ethernet interface.
Table 6 on page 26
on the PTX1000.
Example: Using Network Ports as 40-Gigabit Ethernet Interfaces on page 24
Example: Using Network Ports as 100-Gigabit Ethernet Interfaces on page 25
PTX1000 Port Mapping on page 25

Example: Using Network Ports as 40-Gigabit Ethernet Interfaces

All network ports on the PTX1000 can be configured as 40-Gigabit Ethernet interfaces.
You must configure 40-Gigabit Ethernet interfaces in groups of three network ports.
When the port speed is configured as 40 Gbps on the first port in a port group, all three
ports in the port group operate at 40 Gbps. For example, if you configure port
40-Gigabit Ethernet inteface, ports
Figure 5 on page 24). Table 6 on page 26
can be configured as 40-Gigabit Ethernet interfaces.
Figure 5: 40-Gigabit Ethernet Interface Configuration Uses Three Network Ports
1— 0
When port is configured to operate at
1 2
40 Gbps, ports and also operate at
40 Gbps (in blue).
NOTE: 40-Gigabit Ethernet interfaces are configured using the
fpc 0 pic 0 port port-number speed speed
the first set of three network ports as 40-Gigabit Ethernet interfaces, use the
set chassis fpc 0 pic 0 port 0 speed 40g
configuration, each of the three ports (
command. You configure ports to operate at 40 Gbps
speed option. You configure ports to operate at 100 Gbps
speed option. If you configure a port to operate at 40 Gbps
statement from the configuration at the
hierarchy level and commit the configuration. The network
shows the available combinations for the network ports
1 and 2 are also 40-Gigabit Ethernet interfaces (see
provides the complete list of port groups that
2—
When port
40 Gbps, ports
40 Gbps (in green).
command. For example, to configure
command. After you commit this
, , and
0 1
set chassis fpc 0 pic 0 port
[chassis fpc 0 pic
as a
0
3
is configured to operate at
4 5
and also operate at
set chassis
) operate at 40 Gbps.
2
Copyright © 2018, Juniper Networks, Inc.