Debug Lacp - Dell Catalyst 3130 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands

debug lacp

Use the debug lacp privileged EXEC command to enable debugging of Link Aggregation Control
Protocol (LACP) activity. Use the no form of this command to disable debugging.
Syntax Description
all
event
fsm
misc
packet
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug lacp command is the same as the no debug lacp command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show lacp
OL-13271-03
debug lacp [all | event | fsm | misc | packet]
no debug lacp [all | event | fsm | misc | packet]
(Optional) Display all LACP debug messages.
(Optional) Display LACP event debug messages.
(Optional) Display LACP finite state-machine debug messages.
(Optional) Display miscellaneous LACP debug messages.
(Optional) Display LACP packet debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays LACP channel-group information.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug lacp
B-17