Power Status Leds; Combination Of Leds; Sfp Sfp+ Port Led - Cisco NCS 540 Installation Manual

Appendix

Power Status LEDs

Table 5: Power Status LEDs
LED Label
PWR

Combination of LEDs

Table 6: Fan and Power Status LED Combination
BOOT
For all the conditions below, the system will not boot.
Flashing Red
Flashing Red
Flashing Amber
Flashing Amber
Flashing Amber

SFP SFP+ Port LED

Table 7: SFP and SFP+ Port LEDs
LED Label
STATUS
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
Color
Off
Green
Amber
Red
PWR
Flashing Red
Flashing Amber
Flashing Green
Flashing Red
Flashing Amber
Color
Off
Green
Yellow
Power Status LEDs
Status
Sytem is powered off
All the power supplies are on and
operating normally.
Standby FPGA upgrade is in
progress (this is expected to take
about three to five minutes).
Power redundancy is lost due to a
power feed failure or an internal
power supply failure.
Status
Thermal shutdown at Power Up
MSS Ready Failure
TAM Init Failure
TAM Ready Failure
Secure JTAG Failure
Status
Admin is down
Link is up in 1G/10G ports.
Fault or Error or Link Down
47