Door Glass Adjustment - Honda Civic Service Manual

Door Weatherstrip Replacement
NOTE:
. Take care not to scratch the door.
. Use a clip remover to remove the clips.
1. At the A-pillar, remove the door stop mounting bolt
( A ) .
Fastener Locations
A > : B o t t , 1 B > : C l i p , 1 C > : C l i p , 1 8
Detach the clips (8, C), then remove the door
weatherstrip (D).
Install the weatherstrip in the reverse order of
removal and note these items:
. Replace any damaged clips.
. Make sure the weatherstrip is installed ln the
h o l d e r ( E ) s e c u r e l y .
. A p p l y l i q u i d t h r e a d l o c k t o d o o r s t o p m o u n t i n g
bolt before installation.
. Check for water leaks (see step 7 on page 20-'121.
. Test-drive and check for wind noase.
14.----'
'
'r,
.,'o-,,tL' .
. r r t
Door Glass Adjustment
N O T E :
. Check the weatherstrips and glass run channelfor
damage or deterioration, and replace them if
necessary.
. Wipe the run channel clean with a shop towel.
. Lubricate the run channel with Shin-Etsu grease
P/N 08798-9013.
1. Place the vehicle on a firm, level surface.
2. Remove these items:
. Door panel (see page 20-4)
. Plastic cover {see page 20'2)
3. Carefully move the glass (A) until you can see the
glass mounting bolts (B), then loosen them.
B
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m, 7.2lbf.ft)
Push the glass against the channel (C), then tighten
the glass mounting bolts.
Check that the glass moves smoothly.
(cont'd)
20-11