Door Weatherstrip Replacement; Door Glass Adjustment - Honda Civic 2002-2003 Service Manual

•
•
•
Door Weatherstrip Replacement
NOTE:
• Take care not to scratch the door.
• Use a clip remover to remove the clips.
1. At the A-pillar, remove the door stop mounting bolt
(A).
Fastener locations
A~:
Bolt, 1 B C>: Clip, 1 CC>: Clip, 18
o
1 - - - - - - - -
r
B
L
'c
I······
C
2. Detach the clips (B, C), then remove the door
weatherstrip (D).
3. Install the weatherstrip in the reverse order of
removal and note these items:
Replace any damaged clips.
Make sure the weatherstrip is installed in the
holder (E) securely.
• Apply liquid thread lock to door stop mounting
bolt before installation.
• Check for water leaks (see step 7 on page 20-12).
• Test-drive and check for wind noise.
Door Glass Adjustment
NOTE:
• Check the weatherstrips and glass run channel for
damage or deterioration, and replace them
if
necessary .
• Wipe the run channel clean with a shop towel.
Lubricate the run channel with Shin-Etsu grease
PIN 08798-9013,
1. Place the vehicle on a firm, level surface.
2. Remove these items:
Ooor panel (see page 20-4)
Plastic cover (see page 20-2)
3, Carefully move the glass (A) until you can see the
glass mounting bolts (B), then loosen them.
C
A
~---c=;:--~-J;'~
\~,,~/~, ,f~~
\
• \ \'...."';\'
./~--/-·i:,
"
"
j
B
6x 1.0 mm
9.8 N·m 11.0 kgl.m, 7.2Ibl·ftl
4. Push the glass against the channel (C), then tighten
the glass mounting bolts.
5. Check that the glass moves smoothly.
(cont'd)
20-11