Ctd Sensor Error (Cmyk) - Xerox Phaser 6128MFP Service Manual

CTD Sensor Error (CMYK)

Phaser 6128MFP Service Manual
Caution
Do not run the toner motors for more than a few seconds.
The ADC Sensor has detected a density error for the indicated color. This
troubleshooting procedure applies to this error.
Applicable Errors
• 092-310: CTD Sensor Error (CMYK)
Initial Actions
• Clean the Transfer Belt and ADC Sensor window using a dry cloth.
• Check the indicated Toner Cartridge.
• Check the Imaging Unit for sealing tapes or protective covers.
• Check the Transfer Belt and Imaging Unit life counters. If near end of life,
replace the part.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL4.1.21
Dispense Assembly, PL5.1.1
Toner Cartridge (CMYK), PL5.1.21~24
Toner Motor harness, PL5.1.25
Transfer Belt, PL6.1.7
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Transfer Belt installation.
Is the Transfer Belt correctly
installed?
2 Does the error still occur when the
printer is turned On?
3 Check Left Side Harness continuity.
Disconnect P/J28 from the MCU
Board and P/J281 to the Transfer
Belt.
Is the harness damaged?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 1 - MCU Board" on page 10-6
"Map 4 - Imaging" on page 10-9
"Xerographics" on page 10-18
"Toner Dispense" on page 10-20
Yes
Go to step 3.
Go to step 3.
Repair or
replace the
harness
(PL10.4.18).
No
Reseat the
Transfer Belt.
Go to step 2.
Complete.
Go to step 4.
3-109