Out Of Memory - Xerox Phaser 6128MFP Service Manual

Out of Memory

Phaser 6128MFP Service Manual
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Image Processor Board
for correct installation.
Is the Image Processor Board
correctly installed?
2 Does the error still occur when the
printer is turned On?
The printer controller has detected a memory access error. The following
troubleshooting procedure applies to these errors.
Applicable Errors
• 016-718: Out of Memory Error
• 016-720: PDL Error
Initial Actions
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL10.6.6
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the memory.
Print the Configuration page to
determine installed memory size.
Is the print job too large?
Error Messages and Codes
Yes
Go to step 2.
Replace the
Image
Processor Board
(page 8-41).
Wiring and Plug/Jack Map References
"Map 3 - Electrical and Drive" on page 10-8
Yes
Divide the print
job to fit
installed
memory.
No
Reseat
connections on
the Image
Processor
Board
(page 8-41).
Complete.
No
Go to step 2.
3-115