Out Bin Full - Xerox WorkCentre 3210 Service Manual

Error Messages and Codes

Out Bin Full

Applicable Error Message
Initial Actions
3-18
The Bin Full Sensor indicates the output tray is full.
Out Bin Full
Check the bin full actuator for damage or obstructions.
Cycle printer power.
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Main Controller Board, PL1.0.2
Bin Full Actuator Holder, PL3.0.8
Bin Full Actuator, PL3.0.9
Bin Full Sensor, PL3.0.10
Troubleshooting Procedure Table
Step Actions and Questions
Check the bin full actuator for damage.
1
Is the actuator damaged?
2 Check the connection between the
Main Controller Board CN12 and the
Bin Full Sensor.
Is the connection secure?
Check for +3.3 V at CN12-1.
3
Is +3.3 V present at CN12-1?.
Check the continuity of the bin full
4
harness connecting the Main
Controller Board and Bin Full Sensor.
Is the harness damaged?
WorkCentre 3210/3220 Multifunction Printer Service Manual
Wiring and Plug/Jack Map References
Map 3 - Sensor Locator
Main Controller Board
Yes No
Repair the Go to step 2.
actuator.
Go to step 3. Secure the
connections.
Go to step 4. Replace the
Main Controller
Board
(page 8-100).
Repair the Replace the Bin
harness. Full Sensor
(page 8-70).