Mirroring-Group Reflector-Port - H3C S5830V2 Series Command Reference Manual

Use a monitor port only for port mirroring to make sure that the data monitoring device receives and
analyzes only the mirrored traffic rather than a mix of mirrored traffic and normally forwarded traffic.
Do not configure a port of an existing mirroring group as the monitor port.
Examples
# Create local mirroring group 1, and configure port Ten-GigabitEthernet 1/0/1 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 monitor-port ten-gigabitethernet 1/0/1
# Create remote destination group 2, and configure port Ten-GigabitEthernet 1/0/2 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] mirroring-group 2 monitor-port ten-gigabitethernet 1/0/2
Related commands
mirroring-group

mirroring-group reflector-port

Use the mirroring-group reflector-port command to configure the reflector port for a remote source
group.
Use the undo mirroring-group reflector-port command to remove the reflector port of a remote source
group.
Syntax
In system view:
mirroring-group group-id reflector-port interface-type interface-number
undo mirroring-group group-id reflector-port interface-type interface-number
In interface view:
mirroring-group group-id reflector-port
undo mirroring-group group-id reflector-port
Default
No reflector port is configured for a mirroring group, and a port does not serve as the reflector port for
a mirroring group.
Views
System view, interface view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group. The mirroring group specified by group-id must already exist.
The value ranges from 1 to 4.
interface-type interface-number: Specifies a port to be configured as the reflector port by its type and
number.
125