Address Defaults; Figure 3-6. Gigabit Switch Panel; Table 3-1. Sbm-Gem-001 Switch Module Address Default Settings - Supermicro SuperBlade SBM-GEM-X2C User Manual
Superblade network modules 1/10 gbps
Hide thumbs
Also See for SuperBlade SBM-GEM-X2C:
- Reference manual (985 pages) ,
- User manual (306 pages) ,
- Configuration manual (85 pages)
Table of Contents
Advertisement
Address Defaults
The following are the default addresses that are initially set. Afterwards, you can change
these values within the program.
Table 3-1. SBM-GEM-001 Switch Module Address Default Settings
Address
Default IP Address
Default Gateway Address
Default Subnet Mask
NOTE: If two switches are installed in a SuperBlade system, you will have to
change the IP address of one from the default so that both switches have
unique addresses.
Figure 3-6. Gigabit Switch Panel
Default Setting
192.168.100.102
192.168.100.1
255.255.255.0
7
Chapter 3: Setup and Installation
Advertisement
Table of Contents
