Address Defaults
The following defaults in
Afterwards, you can change these values within the program.
Table 3-1. MBM-GEM-001 Switch Module Address Default Settings
Address
Default IP Address
Default Gateway Address
Default Subnet Mask
NOTE: If two switches are installed in a SuperBlade system, you will have to change the IP
address of one from the default so that both switches have unique addresses.
Table 3-1
are the default addresses that are initially set.
Default Setting
https://192.168.100.102
192.168.100.1
255.255.255.0
3-7
Chapter 3: Setup and Installation