Configure Ospf Area Stub Stub-Default-Cost - Extreme Networks ExtremeWare Command Reference Manual

configure ospf area stub stub-default-cost

configure ospf area <area identifier> stub [summary | nosummary]
stub-default-cost <cost>
Description
Configures an OSPF area as a stub area.
Syntax Description
area identifier
summary
nosummary
cost
Default
N/A.
Usage Guidelines
A stub area is connected to only one other area. The area that connects to a stub area can be the
backbone area. External route information is not distributed into stub areas. Stub areas are used to
reduce memory and computation requirements on OSPF routers.
Example
The following command configures an OSPF area as a stub area:
configure ospf area 0.0.0.6 stub nosummary stub-default-cost 10
History
This command was available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.7 Command Reference Guide
Specifies an OSPF area.
Specifies that type-3 can be propagated into the area.
Specifies that type-3 cannot be propagated into the area.
Specifies a cost metric.
configure ospf area stub stub-default-cost
1811