Modifying A Wireless Ap's Properties Based On A Default Ap Configuration; Modifying The Wireless Ap's Default Setting Using The Copy To Defaults Feature - Extreme Networks Summit WM20 User Manual

9 From the Minimum drop-down list, select the minimum power level below which the power cannot
be further reduced by the DRM.
10 From the Maximum drop-down list, select the maximum power level above which the power cannot
be further increased by the DRM.
NOTE
Due to limited power control resolution, the actual power limits may differ slightly from the settings you define.
11 Click Apply to selected WAPs.
12 To save your changes, click Save.
13 To re-establish baseline settings, forcing the APs to go through the auto-channel selection process,
click Reset DRM. This will cause all APs using DRM to reboot and rerun the auto-channel selection
algorithm.
Modifying a Wireless AP's Properties Based on a
Default AP Configuration
If you have a Wireless AP that is already configured with its own settings, but would like the Wireless
AP to be reset to use the system's default AP settings, use the Reset to Defaults feature on the WAP
Properties tab.
To configure a Wireless AP with the system's default AP settings:
1 From the main menu, click Altitude APs. The Altitude APs screen is displayed.
2 In the Altitude AP list, click the Wireless AP whose properties you want to modify. The WAP
Properties tab displays Wireless AP information.
3 Click Reset to Defaults to have the Wireless AP inherit the system's default AP settings. A pop-up
window asking you to confirm the configuration change is displayed.
4 Click OK to confirm resetting the AP to the default settings.
Modifying the Wireless AP's Default Setting Using the
Copy to Defaults Feature
You can modify the system's default AP settings by using the Copy to Defaults feature on the AP
Properties tab. This feature allows the properties of an already configured AP to become the system's
default AP settings.
To modify the system's default AP settings based on an already configured AP:
1 From the main menu, click Altitude APs. The Altitude APs screen is displayed.
2 In the Altitude AP list, click the Wireless AP whose properties you want to become the system's
default AP settings. The WAP Properties tab displays Wireless AP information.
Summit WM20 User Guide, Software Release 4.2

Modifying a Wireless AP's Properties Based on a Default AP Configuration

79