Disable Icmp Address-Mask - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

disable icmp address-mask

disable icmp address-mask {vlan <vlan name>}
Description
Disables the generation of an ICMP address-mask reply on one or all VLANs.
Syntax Description
vlan name Specifies a VLAN name.
Default
Enabled
Usage Guidelines
Disables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask
request is received. The default setting is enabled. If a VLAN is not specified, the command applies to
all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command disables the generation of an ICMP address-mask reply on VLAN accounting:
disable icmp address-mask vlan accounting
History
This command was first available in ExtremeWare 6.1.
This command was added to the "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
1698 ExtremeWare 7.7 Command Reference Guide