Connecting A Partner-Ca48; Intercom Autodialer - Lucent Technologies PARTNER Advanced Communications System Installation Manual

Connecting a PARTNER-CA48

Intercom Autodialer

The PARTNER-CA48 Intercom Autodialer is shipped with an adapter, a D8W line cord, a power cord, a power unit,
and a button-labeling sheet.
NOTE:
The PARTNER-CA48 Intercom Autodialer can be wall mounted to work next to a wall-mounted system
phone. See the instructions provided with the Autodialer.
1
Plug the adapter into the wall jack.
2
A) Plug one end of the D8W line cord into the J1
jack on the adapter.
B) Plug the other end of the D8W line cord into the
IN jack on the bottom of the autodialer.
3
A) Plug the blue-tinted connector (labeled D8AC) of
the power cord into the jack on the power unit.
!
B) Plug the other end (clear tinted) of the power
cord into the J2 jack on the adapter.
C) Plug the power unit into an electrical outlet.
4
Plug the phone s modular telephone cord (LINE jack) into the OUT jack on the bottom of the
autodialer.
5
A) Arrange the autodialer on the desk next to the
phone.
B) Remove the plastic cover from the autodialer and
label the button sheet with employee names.
Place the button sheet on the autodialer, then
carefully replace the plastic cover.
C) Adjust the height of the autodialer to match the
system phone.
NOTE:
If you unplug the system phone that is connected to an
autodialer, you must reset the autodialer. To do so, unplug the
D8W line cord (connected to the IN jack on the bottom of the
autodialer) from the J1 jack on the adapter, then plug it back in.
28
Installation Procedures
CAUTION:
Use only the power unit supplied with the
PARTNER-CA48 Intercom Autodialer.
Wall Jack
IN
Ext. Message
Intercom Intercom
ABC DEF
+ Feature 1 2 3
GHI JKL MNO
– Conf 4 5 6
Mic PQRS TUV WXYZ
Transfr 7 8 9
HFAI
Spkr Hold * #
0
Power
Outlet
OUT