Configure Jumbo Frames, Lldp, And Spanning Tree - Dell Cisco Catalyst 3850 PS Series Configuration Manual

Sans

Table of Contents

The enable password is used when you do not specify an enable secret password,

with some older software versions, and some boot images.

Enter enable password: <password>

The virtual terminal password is used to protect access to the router over a

network interface.

Enter virtual terminal password: <password>

Setup account for accessing HTTP server? [yes]: no

Configure SNMP Network Management? [no]: <Enter your choice>

Note: The current interface summary is displayed here.

Enter interface name used to connect to the management network from the above

interface summary: GigabitEthernet0/0

Configuring interface GigabitEthernet0/0:

Configure IP on this interface? [no]: yes

IP address for this interface: <management ip address>

Subnet mask for this interface [255.0.0.0]: <subnet mask>

Note: The configuration command script is displayed here.

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

2.4

Configure Jumbo Frames, LLDP, and Spanning Tree

Switch(config)#system mtu 9198

Switch(config)#lldp run

Switch(config)#spanning-tree mode pvst

Cisco Catalyst 3850 Switch Configuration Guide for Dell PS Series SANs | SCG3299

Table of Contents