Interface Specifiers; References - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Interface Specifiers

The configuration task examples in this chapter use the slot/port[.subinterface ] format
to specify an ATM interface. However, the interface specifier format that you use
depends on the router that you are using.
For ERX7xx models, ERX14xx models, and ERX310 router, use the
slot/port[.subinterface ] format. For example, the following command specifies
ATM 1483 subinterface 10 on slot 0, port 1 of an ERX7xx model, ERX14xx model,
or ERX310 router.
For E120 and E320 routers use the slot/adapter/port[.subinterface ] format, which
includes an identifier for the bay in which the I/O adapter (IOA) resides. In the
software, adapter 0 identifies the right IOA bay (E120 router) and the upper IOA bay
(E320 router); adapter 1 identifies the left IOA bay (E120 router) and the lower IOA
bay (E320 router). For example, the following command specifies ATM 1483
subinterface 20 on slot 5, adapter 0, port 0 of an E120 or E320 router.
For more information about supported interface types and specifiers on E Series
routers, seeInterface Types and Specifiers in JUNOSe Command Reference Guide.

References

For more information about ATM interfaces, consult the following resources:
host1(config)#interface atm 0/1.10
host1(config)#interface atm 5/0/0.20
ATM Forum ATM User-Network Interface Specification, Version 3.0 (September
1993)
ATM Forum ATM User-Network Interface Specification, Version 3.1 (September
1994)
ATM Forum Integrated Local Management Interface (ILMI) Specifications,
Versions 3.0, 3.1, and 4.0 (September 1996)
ATM Forum Traffic Management Specification, Version 4.0 (April 1996)
ITU-T Draft Recommendation I.363 (AAL5 support) (January 1993)
RFC 2390 Inverse Address Resolution Protocol (September 1998)
RFC 2684 Multiprotocol Encapsulation over ATM Adaptation Layer 5 (September
1999) (RFC 2684 obsoletes RFC 1483)
ITU-T Recommendation I.610 B-ISDN Operation and Maintenance Principles
and Functions (February 1999)
Encapsulation Methods for Transport of ATM Over MPLS
Networks draft-ietf-pwe3-atm-encap-07.txt (April 2005 expiration)
JUNOSe Release Notes, Appendix A, System Maximums See the Release Notes
corresponding to your software release for information about maximum values
Chapter 1: Configuring ATM
11
References