Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 91

inarp
oam ais-rdi
oam cc
Use the no version to restore the default encapsulation method, aal5snap.
See encapsulation.
Use to enable Inverse ARP on an ATM PVC that resides on an ATM 1483 NBMA
subinterface and uses the default encapsulation method, aal5snap.
For detailed information about how to use this command, see "inarp" on page 55.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#inarp 5
host1(config-vc-class)#exit
Use the no version to restore the default behavior, which disables Inverse ARP
on the router.
See inarp.
Use to configure surveillance parameters for AIS and RDI F5 OAM fault
management cells on an ATM data PVC.
For detailed information about how to use this command, see "oam ais-rdi" on
page 52.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#oam ais-rdi 5 10
host1(config-vc-class)#exit
Use the no version to restore the default values for the alarm down count
(1 successive alarm cell) and alarm clear timeout duration (3 seconds).
See oam ais-rdi.
Use to enable F5 OAM CC verification on an ATM data PVC.
For detailed information about how to use this command, see "oam cc" on
page 52.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example 1 Enables CC verification with a source endpoint
host1(config-vc-class)#oam cc source
host1(config-vc-class)#exit
Chapter 1: Configuring ATM
Configuring ATM VC Classes
61