Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 408

JUNOSe 11.0.x Link Layer Configuration Guide
show pppoe subinterface
378
Monitoring PPPoE
Example 4 Displays the names of all PPPoE service name tables configured on
the router
host1#show pppoe-service-name-table brief
Service-Name Table:
myServiceTable1
myServiceTable2
See show pppoe-service-name-table.
Use to display parameters for PPPoE subinterfaces.
If you do not specify a subinterface, the router displays the configured PPPoE
subinterface number and status for all configured PPPoE subinterfaces.
If you specify an interface with no subinterface, the router displays the status
for the subinterfaces associated with the interface.
If you specify an interface and subinterface, the router displays detailed
parameters available for that subinterface.
To display configuration, status, and statistics information, use the full keyword.
Field descriptions
PPPoE subinterface Interface specifier
Status Operational status of the interface. Possible values are:
operStatusUp Interface or subinterface is operational
Down Interface or subinterface is not operational
LowerLayerDown Subinterface is not operational because an underlying
interface or subinterface is down
URL String URL string sent in the PADM message to PPPoE clients
MOTM String Message of the minute string sent in the PADM message to
PPPoE clients
session id Session ID of the subinterface
source MAC address MAC address of PPPoE client
MTU Maximum transfer unit (MTU) value; when derived from the PPPoE
MTU tag, the value can only be determined from an active session.
In Octets Number of octets received on the subinterface
Out Octets Number of octets transmitted on the subinterface
In Packets Number of packets received on the subinterface
Out Packets Number of packets transmitted on the subinterface
Example 1