Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 625

interface atm
profile
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Use the no version to terminate autodetection of the ATM 1483 encapsulation
type.
See auto-configure atm1483.
Use to select an ATM interface or ATM 1483 subinterface.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 5/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to create a base profile to configure attributes for a dynamic ATM 1483
subinterface.
Specify a profile name of up to 80 alphanumeric characters.
Example
host1(config)#profile atm1483BaseProfile
Use the no version to delete the specified profile if it is not being used by any
existing VC subranges.
Configuring ATM 1483 Dynamic Subinterfaces
595