Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 512

JUNOSe 11.0.x Link Layer Configuration Guide
interface atm
profile
482
Configuring PPP and PPPoE Dynamic Interfaces over Static ATM
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
See auto-configure.
Use to select an ATM interface or ATM 1483 subinterface.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 5/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign a profile.
You must specify the encapsulation type to which the profile applies:
bridgedEthernet, ip, ppp, pppoe ,or any.
Specify a profile name with up to 80 alphanumeric characters.
Example
host1(config-subif)#profile ppp foo